Resetting the Rode Wireless GO II
Turn off both transmitters and the receiver by holding down the power button until the LEDs turn off.

Perform a factory reset on the receiver:

Power on the receiver by holding the power button.
Access the receiver's menu by pressing the middle button.
Navigate to the "Settings" menu using the arrow buttons.
Select "Reset" or "Factory Reset" and confirm the action. This will reset the receiver to its default settings.
Perform a factory reset on each transmitter:

Power on each transmitter by holding the power button.
To reset each transmitter, use a small pin or paperclip to press the reset button located on the side or back of the transmitter (depending on the model). Hold the reset button until the LED blinks.
Reconnecting the Transmitters with the Receiver
Power on the receiver by holding the power button.

Power on each transmitter by holding their power buttons until the LEDs light up.

Pair the first transmitter:

On the receiver, enter the "Pairing" mode by navigating to the pairing menu.
The receiver should automatically detect the first transmitter. If not, follow the on-screen instructions to manually pair the transmitter.
Once paired, the receiver's display should show the connection status for the first transmitter.
Pair the second transmitter:

Repeat the same process to enter the "Pairing" mode for the second transmitter.
Follow the on-screen instructions to pair the second transmitter with the receiver.
Confirm that both transmitters are connected and displayed on the receiver's screen.
Final Check
Test the connection by speaking into each transmitter's microphone and checking if the receiver picks up the audio signal.
Adjust any settings as needed through the receiver's menu for optimal performance.
Your Rode Wireless GO II system should now be reset and reconnected, ready for use.