De'Longhi PAC EL112 CST
44 m², 11000 BTU/h
Questions about De'Longhi PAC EL112 CST
What would you like to know?
0 questions and answers
Helpful answer
I have just received alternative instructions from the manufacturer on how to connect the remote control.
Thanks to Digitec support! .......PAC EL112- PAIRING PROCEDURE
1- Standby Mode
2- Make sure that the LED of the CST RCU flashes red immediately after inserting the batteries
followed by a white line
3- Press and hold the Mode button on the remote control for about 10 seconds until a dot appears on the display.
appears on the display, then you can remove your finger
4- Press the arrow button on the air conditioner until a dot appears on the display, then withdraw your finger.
then withdraw your finger.
5- Please note that a rapid white light should flash at the end on the remote control
which means that the pairing is working!
Note: You have to hold the arrow button for a really long time until a small square starts to light up! and only then did I press the mode button for 10 seconds! If you have any questions, please write here.
Galaxus
7 months ago
Yes, you must install the exhaust air hose to the outside. The appliance is supplied with an exhaust air hose that is connected to the back of the air conditioner and routed outside through a window or external wall to remove the warm air. A window bracket or wall flange is usually used for this, and it is necessary to drill a hole of about 150 mm diameter in the outside wall or window to connect the hose.
Automatically generated from the .Galaxus
9 months ago
With this mobile monobloc air conditioner, it is possible to open the lid of the water tray to drain the condensation water. However, the appliance is not designed as standard to continuously drain the condensation water into a drain via a hose. The condensation water collects in the tray and must be drained manually by removing the cap at the back and allowing the water to run off. Direct connection of a hose for permanent condensation drainage is not described in the operating instructions.
As the exhaust air is channelled through the chimney and as little condensation water as possible should reach the chimney, it is recommended that the water tray is emptied regularly to minimise condensation in the exhaust air hose. A special connection for a condensation hose is not provided on this model.
Automatically generated from the .
Galaxus
9 months ago
The water produced during dehumidification is collected in an internal container of the appliance, which must be emptied regularly. Alternatively, a drain hose can be connected to some mobile air conditioners to continuously drain the water; please refer to the operating instructions to check whether this is possible with the model mentioned.
The appliance does not necessarily have to be positioned directly at the window, but the exhaust air hose must be routed to the outside, typically through a window, so that the warm air can be discharged. A window sealing set is usually used for this purpose to guide the hose safely and tightly out of the window. A fixed window position is therefore necessary to position the exhaust air hose correctly.
Automatically generated from the .
Helpful answer
The accessories supplied are exactly as shown in the pictures.
Helpful answer
I bought this item from the Galaxus catalogue and it works well:
VidaXL Air exhaust hose 6 m Ø15 cm
Helpful answer
Hello, if the appliance is integrated into the home network (Wi-Fi), the appliance can be started remotely via the DeLonghi app. It didn't always work for us, but for the most part it worked quite well. Greetings
Helpful answer
Problem solved - the manual does not have good instructions.
9 of 9 questions