Glade Sense & Spray automatically releases a fragrance when the Smart Motion Sensor is active and detects movement. After detecting movement and spraying, the device automatically switches to standby mode. The scents created by Glade fill any room with a mood-enhancing fragrance that creates a special atmosphere of well-being.

Placement: Ideally, place the device upright on a flat surface without obstructing the upward spray. Maintain a distance of about 1.50 meters from the source of movement.

Operation: To open the device, press on both sides near the middle and lift the front cover. Insert the fragrance cartridge into the device. A audible click confirms the correct position of the refill. Note: Only use Glade Sense & Spray refills in this device. Pull out the red tab on the battery to activate it. After 5 seconds, the device will automatically spray once to indicate that it is ready for use. When the device detects movement, it will blink three times quickly and spray briefly. It then goes into standby mode for 20 minutes. In standby mode, the light stays on continuously, and Glade Sense & Spray does not respond to movement or spray. After 20 minutes in standby mode, the light blinks every 5 seconds, and the device is now active again. It will respond to movement and spray as needed. If 20 minutes is too long, the Boost button on the front of the device, where the light is illuminated, can be pressed to receive an extra burst of fragrance.

Battery replacement: Remove the front cover. Insert two new AA batteries. Note: Arrange the batteries correctly when replacing them. Dispose of old batteries at collection points at recycling centers. Empty cartridges can be disposed of through the waste separation system "Der Grüne Punkt.".