BAN wind bracing bands can be used in various construction applications, primarily for the bracing of roof structures, where they are employed as tension rods. Corrosion protection: 275 g/m² on both sides, corresponding to a zinc layer thickness of approximately 20 μm. BAN154025 and BAN154050 are made from the higher load-bearing S350GD steel; zinc layer thickness approximately 20 μm. BAN094050 is made from S550GD + Z275. Attachment options: Connection to wood is made with CNA4.0xℓ comb nails or CSA5.0xℓ screws. The connection to the Simpson Strong-Tie wind bracing system is made with clips or screws M5x12 (strength 8.8). Advantages: The versions BAN154025, BAN154050, BAN156050, BAN204025, and BAN204050 are equipped with a meter marking from 0.5 to 25 m, or 50 m. Note: For larger loads, multiple bands can be installed side by side. In these cases, BNSP tensioning devices are recommended to ensure even tensioning of the bands. It must also be checked whether, given the current rafter width, sufficient comb nails can be installed in the wind bracing band while considering the required edge distances. Otherwise, the rafter must be widened with additional wood, or the wind bracing band must be connected to the wind bracing system. Application: Versatile use in construction, specifically for the bracing of roof structures. Since the wind bracing band can only absorb tensile forces, at least two diagonally opposing bands must be used per area. Fastening: Comb nails CNA4.0xl or screws CSA5.0xl. Also available in stainless steel (upon request). EN 14545. Corrosion protection: 275 g/m² on both sides, corresponding to a zinc layer thickness of approximately 20 μm. BAN154025 and BAN154050 are made from the higher load-bearing S350GD steel; zinc layer thickness approximately 20 μm. BAN094050 is made from S550GD + Z275.