The practical success package "Installing Laminate and Design Flooring" from wolfcraft contains everything you need for compressing the rows when laying laminate and design floors. Included are a pull bar, a tapping block, and 30 universal wedges. The tapping block is an indispensable tool for aligning parquet and laminate planks without gaps and evenly. Simply place it at the end of the plank and compress the material with a targeted hammer strike on the striking surface. To optimally protect the tongue and groove during compression, the tapping block is equipped with a special longitudinal profile suitable for any plank thickness. The pull bar comes into play in the areas touching the wall. Simply position it in the gap between the wall and the plank and apply controlled strikes in the pulling direction with the hammer. This ensures a perfect surface appearance. Three felt gliders on the underside protect the material and allow for gentle application. Ideal for use at the ends of a room or to push laminate under the door frame for clean finishes. To create a continuous expansion joint, use the 30 universal wedges. They can be pushed together in two directions, allowing you to combine the clever helpers into either a flat spacer or a larger wedge. Thanks to the notches, you can precisely determine the thickness of the spacer and pre-set multiple wedges to the same measurement. Once inserted and adjusted, the wedges reliably maintain their position and thickness, saving you from frequent re-adjustments. Not only essential for laying parquet or laminate but also ideal for installing windows and doors and many other tasks. Complete set consisting of a pull bar, tapping block, and 30 universal wedges. Three problem solvers for compressing laminate and design flooring rows and for setup.