RJ Tianye RJ-C 121001A
12V, 24V, 10 A
Question about RJ Tianye RJ-C 121001A
User manual
Galaxus
10 months ago
The user manual for the RJ-C 121001A 12V 10A / 24V 5A battery charger indicates the following main steps:
1. Connect the red clamp to the positive (+) pole of the battery and the black clamp to the negative (-) pole.
2. Once the poles are correctly connected, the LCD screen will light up and display the battery voltage and ambient temperature alternately.
3. If the poles are reversed, the device displays a "reverse connection" error message and an EI-I- code.
4. Once the battery has been correctly connected and switched on, the charger will automatically start charging. The display cycles through voltage, current and ambient temperature.
5. The charger automatically selects the optimum charging parameters according to the type of battery (lead-acid, AGM, gel, etc.).
6. A recovery mode is available for old or discharged batteries.
7. When charging is complete, the battery power bar on the display shows 100%. It is recommended to continue charging in float mode for 1 to 2 hours.
8. To disconnect, first disconnect the mains plug, then remove the battery clips.
This charger is suitable for 12 V and 24 V lead-acid batteries, with capacities ranging from 2 Ah to 150 Ah, and incorporates protection against short-circuit, reverse polarity, undervoltage, overcharging, overheating and overvoltage.
Automatically generated from the .1. Connect the red clamp to the positive (+) pole of the battery and the black clamp to the negative (-) pole.
2. Once the poles are correctly connected, the LCD screen will light up and display the battery voltage and ambient temperature alternately.
3. If the poles are reversed, the device displays a "reverse connection" error message and an EI-I- code.
4. Once the battery has been correctly connected and switched on, the charger will automatically start charging. The display cycles through voltage, current and ambient temperature.
5. The charger automatically selects the optimum charging parameters according to the type of battery (lead-acid, AGM, gel, etc.).
6. A recovery mode is available for old or discharged batteries.
7. When charging is complete, the battery power bar on the display shows 100%. It is recommended to continue charging in float mode for 1 to 2 hours.
8. To disconnect, first disconnect the mains plug, then remove the battery clips.
This charger is suitable for 12 V and 24 V lead-acid batteries, with capacities ranging from 2 Ah to 150 Ah, and incorporates protection against short-circuit, reverse polarity, undervoltage, overcharging, overheating and overvoltage.