The FOXY Brushed series DC motors are perfect for a wide range of modeling applications - for powering airplanes, ships, cars, tanks, and other land vehicles with direct drive and gears. When installing and connecting FOXY Brushed motors, make sure not to exceed the permissible values for supply voltage and current load. Motor cooling: During operation, the temperature of the motor's outer casing should not exceed 80 °C. Therefore, it is always necessary to ensure sufficient access for cooling air and its circulation around the motor in the model. For ship models, we recommend using water cooling. High motor loads are only possible for short periods. After each flight or drive, the motor must cool down to room temperature before restarting. The FOXY 600 7.2 V is a DC electric motor of size "550" with a shaft diameter of 3.175 mm and sliding bearings, suitable for powering model airplanes (e.g., motor gliders with a wingspan of 1800-2000 mm) with direct drive (7x4" propeller) or with gears, as well as for small car and ship models (propeller 30-35 mm). To control its speed, you will need an electronic speed controller with a capacity of 30-40 A. The FOXY 600 7.2 V is a suitable replacement for the Speed Motor 600 7.2 V. The motor set includes: the FOXY 600 7.2 V motor and the manual 3BD1025.