8W x 2 Flashlight, 11 mm, short, T-Fuse. Powerful flashlight in x2 technology - double the light output with the same heat dissipation! The profile light of the 11 mm series is very slim on the outside and visually fits smaller models as well. However, due to the x2 technology, it has an enormous light output, making it an absolute eye-catcher even for larger models. The profile-shaped polycarbonate cap is only clipped on in its delivered state. It can be painted separately, is highly transparent, and shatterproof. Upon request, the light can also be installed recessed by up to 4 mm, or the cap can be ground down to achieve an even smaller form factor. The cap must be glued after final assembly. This light has been designed without additional cooling surfaces to allow for an extremely flat and compact installation, especially on fuselage backs, bottoms, or wing tips. Therefore, this light is exclusively suitable for flash or short blink operation. To ensure the operational safety of the light and model, there is an over-temperature fuse on the underside of the unit. If the light is operated for too long and becomes too hot, this switch will turn off the light. To increase the lifespan, this function should not be used continuously! The light is pre-assembled for operation on 2S Lipo (approximately 8V). When operating with 3S (12V), the included resistor must be used; alternatively, you can also use an 8W-3S adapter cable. After installation, check the operating temperatures. PRO11XF-080x2-RT.