Lian-Li Strimer Plus V2
RGB
Question about Lian-Li Strimer Plus V2
I have a problem with my build. I have the Asus Rog Rtx 4090 matrix GPU. 1600w PSU from Asus. Original 12vhpwr cable to this strimer and then into the GPU. Quite tight, but is completely inside (vertically mounted) I have the problem with every boot that I have a black screen after a while and the fans go to fullspeed. Researched on the internet, it is said to be because the cable is too close to the wall of the GPU, or because the sense pins are not completely in. It really is in the port of the GPU up to the connection point, so I'm a bit desperate.
Hello, you could remove the lian li strimer plus cable and connect the original cable direct to the graphic card if the problem persist so it is not the lian li cable it could be the power supply original cable or it could be the graphic card
I'm still waiting for my hub then I can build to the Strimer Plus V2 that comes in the rtx 4090 geschtekt then only come the original cable where then go into the power supply and yes it should not be too much bent
Edit: 3 last line: It really is up to the hilt*