EUR27,90
D-Link Dgs-108
8 ports
Question about D-Link Dgs-108
My line goes in as subscribed with 200/200. The D-Link turns this into 90/90 at the outputs. Is this normal? Thank you for your help.
Helpful answer
No, your switch should not "cap" at ~90 Mbps. This is almost always a cable or negotiation problem.
- Troubleshooting tips:
Test the speed without the switch directly on the router/modem → will you get 200/200?
Test a different LAN cable (Cat5e or Cat6, four pairs throughout).
Check the connection speed of your network card in Windows/Linux/Mac ("100 Mbit/s" or "1.0 Gbit/s").
Swap the ports on the switch.
If all else fails → switch may be faulty.
- Troubleshooting tips:
Test the speed without the switch directly on the router/modem → will you get 200/200?
Test a different LAN cable (Cat5e or Cat6, four pairs throughout).
Check the connection speed of your network card in Windows/Linux/Mac ("100 Mbit/s" or "1.0 Gbit/s").
Swap the ports on the switch.
If all else fails → switch may be faulty.
PS: The LEDs all light up green.