The JUNG emergency call system consists of a pull switch, a call module, a reset button, and a power supply (screw mounting, without mounting claws) and is available complete with a single frame. It is designed for emergency calls in accessible toilet facilities and meets the safety requirements according to DIN VDE 0834.

The emergency call system is modular and includes the following four components:

• **Pull Switch**: An emergency call can be triggered in the bathroom or toilet via an easily accessible pull cord. The pull switch can also be installed in the middle of the room on the ceiling to be easily reachable for those in need of assistance. A successful call activation is indicated by a red reassurance lamp on the switch.

• **Call Module**: The call module can be installed outside next to the toilet door or hallway door, for example. An activated emergency call is visually signaled by a red LED and acoustically by a buzzer with 90 dB(A). Both signals can be switched from continuous light/continuous tone to flashing light/pulsating tone.

• **Reset Button**: In the same room where the pull switch is located, the reset button is installed next to the door. The assisting personnel can use it to cancel the activated call.

• **Power Supply**: For powering the emergency call system with DC 24 V. The service room unit, service room terminal, and call button are available separately. The service room unit can be installed, for example, in a staff or reception area. A green button indicates presence, while a yellow button suppresses the acoustic emergency call signal of the call module for 20 seconds.

The components of the JUNG emergency call system can be complemented with frames from the AS / A, CD, or LS series, allowing for a uniform design throughout the building. The complete emergency call set already includes the frames. For expanding a system, the components are also available individually.