EUR71,10
Shelly 3EM
Questions about Shelly 3EM
What would you like to know?
0 questions and answers
Helpful answer
No, it can only be used to measure a 3-phase consumer or producer. Shelly has its own devices for one phase
yes
Helpful answer
Device: 73 x 57 x 22 mm
Pliers: 23,5mm x 41,5mm x 26mm
Helpful answer
if the devices are connected 1-phase, 1 device should be sufficient (see the instructions).
the pro variant has a different design and therefore fits better on a standard tableau.
the pro version is not fully compatible with the protocol and offers less possibilities to read out the values. so check what is supported by your software.
Helpful answer
Yes, without problems. You just have to combine the voltage lines with the right clamps.
Solder on the corresponding plugs. Otherwise, the supplied "flip sensors" are calibrated with the EM3 to the respective phase and are therefore labelled separately. If the phase is mixed up or a 50A version is used, at least the calibration (with a measuring load) must be started. However, I cannot say whether the EM3 also tolerates other "flip sensors".
Helpful answer
The cable is 65cm long from the plug to the transducer
Hello Eskimo
If you know when your tariff is low, you can simply set the timer with the day of the week.
Helpful answer
You can operate the Shelly from all over the world via the cloud. On the wifi, it will work from both.
Hello Shopping
The Shelly 3EM is a first generation device.
From the second gen. are all the newer products like the i4, Pro Series (1, 2,1PM,2PM,4PM), the Plus Series (1PM,2PM), and as far as I know also Motion2
Hello
The data is transferred to the PC (web interface) or to the mobile phone using the app. I had to wait about 3 weeks for my 3EM.
Unfortunately I'm not satisfied with it, at the beginning it worked great, but after a while it doesn't work anymore, I can't get into the interface 192.168.33.1 anymore, it always asks for admin and password, which I never set, but now I can't get in, password unknown 12345678, it can't be reset in the factory settings?
Is there a way?
21 of 21 questions