I have an Ethernet connection (without PoE) in my flat, which leads to the landlord's router. I am allowed to use his WLAN network, but it is too weak in my home. Is it right that I need a switchbox there to connect the TV and an access point to it or is there an access point that has network operation and Ethernet and a connection for the TV? Does anyone have a good recommendation? Thank you very much!

  0

How do I get the full power, no power uphill at all. I bought this scooter because of its good performance and now I can't even get up the hill with 1600W. There were no instructions in German either.

  1

Hello, We have the Salt Fibre x6 box (black box). We have connected a TP-Link TL-SX195 switch (https://www.digitec.ch/de/s1/product/tp-link-tl-sx105-5-ports-netzwerk-switch-15794920) to port 5 (10GBit). After just a few seconds, the switch causes a fault in the network. All connections to the Internet become extremely slow. The connection speed drops to 10 KBit and even to zero. I suspect a bufferbloat. Which the CNLab bufferfloat test seems to confirm. Immediately when I remove the connection on port 5, the speed goes back to normal. I suspect that the switch and salt box are not compatible. Does anyone have a 10Gbit switch on this port 5 with which it works? If so, I would appreciate a short message. Thank you

  1

Recharger for Roventa cordless hoover

  1

I haven't been able to make calls properly for a few weeks now and sometimes I can't be reached. After restarting the mobile/ switching flight mode on/off it works for a few hours, then the problem occurs again. According to Yallo, the reason is that the 3G antennas are switched off and I would have to switch Volte on/set it as the default. However, this is not possible in the settings. Does anyone know a solution or have the same problem? Oppo is unfortunately not available for help and chatgpt has not helped either.

  2